Skip to content

Water Hardness in Concord, New Hampshire

Does Concord have hard water?

No. The water is soft.

Concord Water Department delivers water at 14 ppm (0.8 grains per gallon), which this site rates Soft and the USGS classifies as soft (0–60 mg/L as calcium carbonate). That is about the same as the New Hampshire average of 15 ppm, and softer than 97% of the 428 cities listed on this site.

Hardness 14 ppm 0.8 grains per gallon
USGS Class Soft No softener needed
Rank in NH 5 of 8 hardest first
Water Source Surface Concord Water Department

14 PPM in Every Unit

Appliance manuals, test strips and utility reports each use a different hardness unit. These are the same Concord reading expressed in each one.

UnitConcordUsed by
mg/L as CaCO₃ (ppm)14Utility water-quality reports, USGS
Grains per gallon (gpg)0.8Softener sizing, most US dishwasher manuals, test strips
German degrees (°dH)0.8European-made dishwashers and coffee machines
French degrees (°fH)1.4Some filter and descaler instructions
mmol/L0.14Laboratory reports

Dishwasher setting for Concord: 0.8 gpg or 0.8 °dH, rounded up to the machine's nearest step. The USGS bands are soft 0–60, moderately hard 61–120, hard 121–180 and very hard above 180 mg/L; this site splits the top band at 250 to separate hard from very hard.

What 14 PPM Does in a Concord Home

At 14 ppm there is no scale to speak of. Soap lathers freely, glassware dries clear and a water heater on this supply holds its rated efficiency. A softener would have nothing to remove.

Water heaters

The clearest measured effects of hardness come from a 2009 study the Water Quality Research Foundation commissioned from the Battelle Institute. Scaled to Concord's 0.8 gpg, its gas storage-heater results work out as follows; softened water held full efficiency in the same tests.

ApplianceBattelle findingAt 0.8 gpg
Gas storage heater, 50 gal hot water/day4% efficiency loss per 5 gpg over 15 years1% loss
Gas storage heater, 100 gal/day8% per 5 gpg, capped at the 48% measured at 30 gpg1% loss
Electric storage heater0.4 lb of scale per year per 5 gpg0.1 lb/year
Tankless gas heaterPlugged with scale after 1.6 years on 26 gpg waterLow risk
ShowerheadsLost 75% of flow in under 18 months on hard waterOccasional vinegar soak

Laundry and dishes

Hardness minerals bind with detergent before it can clean, which is why dose charts step up for hard water. For Concord: Use the label's minimum dose; soft water needs no extra detergent.

Where Concord's Water Comes From

Concord Water Department supplies Concord from surface water (rivers, lakes and reservoirs). Surface water has little contact with mineral-bearing rock, so its hardness mostly reflects the watershed's geology and tends to run lower and steadier than well water.

The supply has a pH of 6.8, inside the EPA secondary range of 6.5–8.5, and total dissolved solids of 24 mg/L, well under the EPA secondary standard of 500 mg/L. Hardness is the largest part of dissolved solids in most municipal water, which is why the two tend to rise together.

The figure on this page is the utility's reported average. Blended systems vary by season and neighborhood, so for the current number check the utility's Consumer Confidence Report, which the EPA indexes at Find Your Local CCR, or test the tap with a strip kit.

Other Cities in New Hampshire

Concord ranks 5 of 8 listed New Hampshire cities, hardest first. Hardness tracks geology and source more than distance, so neighboring cities can differ widely.

CityHardness (PPM)GPGLevelSource
Concord 14 ppm 0.8 Soft Surface
Portsmouth 22 ppm 1.3 Soft Ground
Dover 20 ppm 1.2 Soft Ground
Nashua 18 ppm 1.1 Soft Mixed
Rochester 16 ppm 0.9 Soft Ground
Manchester 12 ppm 0.7 Soft Surface
Lebanon 12 ppm 0.7 Soft Surface
Keene 10 ppm 0.6 Soft Surface

Frequently Asked Questions

Does Concord have hard water?

No. The water is soft. Concord's water measures 14 ppm (0.8 grains per gallon), which the USGS classifies as soft (0–60 mg/L as calcium carbonate). That is about the same as the New Hampshire average of 15 ppm and softer than 97% of the 428 cities listed on this site.

What is the water hardness in Concord in grains per gallon?

0.8 grains per gallon. The same 14 mg/L reading is 0.8 German degrees (°dH), 1.4 French degrees (°fH) and 0.14 mmol/L; 1 grain per gallon equals 17.1 mg/L as calcium carbonate.

Do I need a water softener in Concord?

No. At 14 ppm Concord's water is soft and there is nothing for a softener to remove. Spend the money on a filter if taste is the concern.

What size water softener does a family of four need in Concord?

None. Concord's water is soft (14 ppm), so no softener is needed at any household size.

What hardness setting should my dishwasher use in Concord?

Set it for 0.8 grains per gallon, or 0.8 °dH if the manual uses German degrees; most machines take the nearest step up. The setting controls how much rinse aid and, on models with a built-in softener, how much salt the machine uses.

Where does Concord's water come from?

Concord Water Department supplies Concord from surface water (rivers, lakes and reservoirs). Surface water has little contact with mineral-bearing rock, so its hardness mostly reflects the watershed's geology and tends to run lower and steadier than well water. The utility's annual Consumer Confidence Report lists the current hardness, pH and dissolved solids; the EPA keeps a finder for these reports.

How does Concord compare with other cities in New Hampshire?

Concord ranks 5 of 8 New Hampshire cities listed here, hardest first, and is about the same as the New Hampshire average of 15 ppm. Nationally it is softer than 97% of the 428 cities listed on this site; the median listed city is 125 ppm.

How This Page Works

  • The hardness, pH, dissolved-solids, source and utility values are the figures reported by Concord Water Department; every other number on the page is arithmetic on them. The site's five-band scale (soft, slightly hard, moderately hard, hard, very hard) is shown alongside the four-band USGS classification.
  • Unit conversions use 17.1 mg/L per grain per gallon, 17.85 mg/L per °dH, 10 mg/L per °fH and 100.09 mg/L per mmol/L of calcium carbonate.
  • Softener sizing assumes 75 gallons per person per day, regeneration every 7 days, standard capacities from 24,000 to 80,000 grains and 1 lb of salt per 3,000 grains. A dealer will size from your meter and a tap test.
  • Water-heater figures scale the Battelle Institute's 2009 per-5-gpg results linearly to this city's hardness and cap at the 48% loss Battelle measured at 30 gpg; the study ran 90-day accelerated tests, not 15 real years.
  • Sources: USGS Water Science School, Hardness of Water (classification bands); Water Quality Research Foundation, Battelle study release, April 13 2010 and WQA's Softened Water Benefits Studies page; US EPA, Secondary Drinking Water Standards (TDS 500 mg/L, pH 6.5–8.5) and Consumer Confidence Reports.

Test & Treat Your Water

Find out exactly what's in your water and get the right solution.

Some links above are affiliate links — if you buy through them we may earn a small commission at no extra cost to you. As an Amazon Associate we earn from qualifying purchases.